Hoe gebruik je LAN test?

Hoe gebruik je LAN test?

Op de netwerkkabeltester worden de cijfers 1 tot en met 8 weergegeven die staan voor het aantal aders waaruit de kabel bestaat. Wanneer de kabel op de tester is aangesloten zal het lampje één voor één de cijfers 1 tot en met 8 weergeven. Dit betekent dat de aders op de juiste manier zijn aangesloten.

Hoe test ik een UTP kabel?

Controleer de lampjes op de tester. De tester zal elke pin één voor één testen. Als alle 8 pinnen aan beide uiteinden oplichten, is de kabel goed. Als een van de lampjes aan een van de uiteinden niet oplicht, betekent dit een kortsluiting in de kabel. Maak je geen zorgen als het G-lampje niet oplicht.

What are the diagnostic codes used on Caterpillar machines?

The diagnostic code information that follows is utilized by Caterpillar machines that are equipped with Caterpillar electronic controls. Component identifiers, failure mode identifiers, and module identifiers are pieces of information that assist service personnel in diagnosing system problems of the machine.

What are the different types of codes generated by ECM?

If the ECM detects a problem, a code is generated. Diagnostic Code – A diagnostic code indicates an electrical problem such as a short or an open in the engine’s wiring or in an electrical component. Event Code – An event code is generated by the detection of an abnormal engine operating condition.

What is the difference between a diagnostic code and event code?

Diagnostic Code – A diagnostic code indicates an electrical problem such as a short or an open in the engine’s wiring or in an electrical component. Event Code – An event code is generated by the detection of an abnormal engine operating condition. For example, an event code will be generated if the oil pressure is too low.

What does an event code mean on a car?

For example, an event code will be generated if the oil pressure is too low. In this case, the event code indicates the symptom of a problem. Event codes indicate mechanical problems rather than electrical problems. Flash Code – Diagnostics and events are reported via flash codes.